This would not be the case if you were doing the 'startup' config though and were testing to see if it is set to the default value.

To ensure the port is available for use again in a HA cluster, the IP address must be manually. Load-balancing mode is intended for two-factor authentication deployments, as only a subset of the configuration is synchronized between the devices. Show commands display the FortiAI configuration that is changed from the default setting. Fortigate Show Running Config Upgrade Takes Place Fortigate Show Running Config Upgrade Takes Place. With the running config, if you want to make sure something is set to a non-default setting, you should check for its presence, while if you're checking to see if it is set to the default, check to see if it is NOT present. controller copy running-config startupconfig, Saves the running-configuration to the startup configuration to make it persistent. Show and show full-configuration commands. You should probably document your rules as to which configuration you should look at also. Although not explicitly shown in this section, for all config commands, there are related get and show commands which display that part of the configuration. The auto-script output is stored in the RAM, so if you run multiple scripts with a maximum of default 10MB (set output-size. In FortiOS it is possible to configure auto-scripts and this feature can be used for various purposes. This article describes how to use the automated scripting on FortiGate.

Run these commands: On Cisco firewalls: show running-config. Technical Tip: Automated script execution. For a virtual device, make sure to connect directly to the virtual device (not through the parent device). The difference is MASSIVE! On a box I play with the running config is ~3100 lines long, still unbelievably long! But, the startup (or 'show full-configuration') is over 33000 lines long, so more than 10X as long.Īs far as which one to check for in compliance, it can go either way as long as you're consistent. To get a policy configuration file from other devices: Open a command line to the device. But, if you want to see absolutely everything, instead of just typing in 'show' to see the configuration, you type in 'show full-configuration' and it shows absolutely everything including those items set to their default values. Yes, the fortigate has tons of settings on it, and most of them tend to remain at their defaults.

Fortigate show running config